DOI10.5281/zenodo.12812088Zenodo12812088MaRDI QIDQ6704982FDOQ6704982
Dataset published at Zenodo repository.
Tatiana I. Fernandez Perez, Paraskevi Nomikou, Susan Debari, Olga Koukousioura, Acacia Clark, Katharina Pank, Masako Tominaga, Xiaohui Li, Hehe Chen, Shun Chiyonobu, Kumar Batuk Joshi, Yuzuru Yamamoto, Christopher Jones, Jonas Preine, Timothy H. Druitt, Michael Manga, Alexis Bernard, Sarah Beethe, Paraskevi N. Polymenakou, Ralf Gertisser, Carole Berthod, Raymond M. Johnston, Steffen Kutterolf, Adam Woodhouse, Antony Morris, Christian Hübscher, Iona McIntosh, Gunther Kletetschka, Ally Peccia, Molly McCanta, Thomas A. Ronge
Publication date: 30 July 2024
Copyright license: Creative Commons Attribution 4.0 International
Moisture and density (MAD) data were acquired on ~10 mL sediment or rock samples by measuring three out of four material parameters: wet (saturated) mass, wet volume, dry mass, and/or dry volume after 24 h drying in a convection oven at 105 degrees C. From the moisture and volume measurements, the following phase relationships are calculated: wet and dry water content, wet bulk density, dry bulk density, grain density, porosity, and void ratio. The combination of measurements is defined by the submethod chosen: A, B, C, or D. Wet (A, B, or C) and dry (A, B, C, or D) mass is determined using motion-compensated balances. Wet volume is determined either by helium pycnometry (A) or by the sample's geometric dimensions using calipers (A or D). Dry volume (C or D) is measured by helium pycnometry. Submethods A and B are not recommended by IODP. Submethod C is suitable for saturated materials such as fine-grained sediments. Submethod D is suitable for unsaturated porous material such as certain limestones and basalts.
This page was built for dataset: IODP Expedition 398 Moisture and Density
