On some simple steady forming process of viscoplastic solids
axially-symmetric conditionsconical diesconventional viscoplastic materialsdrawing tension attains a minimumEulerian frame of referenceEulerian strain rateexact solutionsexistence of optimum die anglesextrusion processesflow patternslong and tapered diesnearly radialplane-strainpurely viscous solidsreduced to a single nonlinear differential equationsmall wall frictionSteady drawingsteady flowstrain-hardening materialsum of a plastic part and a viscous partviscoplastic constitutive lawvon-Mises flow rulewedge-shaped
Steady drawing and extrusion processes of conventional viscoplastic materials, through wedge-shaped and conical dies, are analyzed. The basic material model assumes that the Eulerian strain rate is the sum of a plastic part and a viscous part. The investigation is restricted to relatively long and tapered dies with small wall friction. Within these limitations it is permissible to treat the flow patterns as being nearly radial. The problem is thus reduced to a single nonlinear differential equation. A few exact solutions are obtained and a further analysis is given for purely viscous solids. For the latter case we demonstrate the existence of optimum die angles where the required drawing tension attains a minimum.
- Rate effects in steady forming processes of plastic materials
- On generalized radial flow patterns of viscoplastic solids with some applications
- Steady forming processes of plastic materials with their rotation
- A mathematical model of tube drawing without plug.
- A mathematical model of the theory of tube drawing with floating plug
- Axially Symmetric Radial Flow of Rigid/Linear-Hardening Materials
- Drawing and extrusion of composite sheets, wires and tubes
- Drawing of Tubes
- scientific article; zbMATH DE number 3061938 (Why is no real title available?)
- Plane-strain radial flow of plastic materials
- Pseudo-plastic converging flow
- Radial flow simulation of drawing and extrusion of rigid/hardening materials
- Rate effects in steady forming processes of plastic materials
- On generalized radial flow patterns of viscoplastic solids with some applications
- A mathematical model of the theory of tube drawing with floating plug
- Steady forming processes of plastic materials with their rotation
- A mathematical model of tube drawing without plug.
- scientific article; zbMATH DE number 3852540 (Why is no real title available?)
- Unstable modes of deformation in solid-phase extrusion of viscoelastic structured systems
- Wall friction effects and viscosity reduction of gel propellants in conical extrusion
- scientific article; zbMATH DE number 784194 (Why is no real title available?)
- Paths swept out by initially slack flexible wires when cutting soft solids; when passing through a very viscous medium; and during regelation
- The converging flow of viscoplastic fluid in a wedge or cone
- A parametric investigation of blood flow in a wedge with non‐uniform viscosity and wall friction
- Rate effects in steady forming processes of plastic materials
This page was built for publication: On some simple steady forming process of viscoplastic solids
Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q1069734)
