Locating defective components in linear systems given as block diagrams. III
[For Parts I, II see ibid. 46, No.3, 369-375 (1985); translation from Avtom. Telemekh. 1985, No.3, 104-110 (1985; Zbl 0577.93010) and ibid. 46, No.4, 502-509 (1985); translation from Avtom. Telemekh. 1985, No.4, 110- 117 (1985; Zbl 0577.93011).] The approach to locating defective components in linear systems, which has been described in previous installments of this article for the case of unidimensional components, is generalized for multidimensional components. Just as before, the examination is conducted on the assumption that internal and external noise are not present in the system being tested. The groundwork is laid for using this approach when small disturbances are present.
- Locating defective components in linear systems given as block diagrams. II
- Locating defective components in linear systems given as block diagrams. I
- An approach to locating defects in linear dynamic systems
- Detection of faulty components in linear dynamical systems
- Detection of faulty components in linear systems accounting for errors in identification
- Failure identification for 3D linear systems
- Diagnosis of subsystems in linear systems
- The determination of defectiveness of linear structural dynamic systems
- Robust fault diagnosis of linear systems
- Sensor Location for Diagnosis in Linear Systems: A Structural Analysis
This page was built for publication: Locating defective components in linear systems given as block diagrams. III
Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q1820100)
