A combined upper-bound and elastic-plastic finite element solution for a fastener hole subjected to internal torsion

DOI10.1007/S00419-011-0566-4MaRDI QIDQ396116zbMATH OpenOpenAlexFDO

Authors A. H. Shamdani, S. Khoddam

Publication date 8 August 2014

Published in Archive of Applied Mechanics (Search for Journal in Brave)

Full work available at URL https://doi.org/10.1007/s00419-011-0566-4

zbMATH Keywords

finite element methodfastener holeinternal torsionlocalized severe plastic deformationupper-bound analysis

Mathematics Subject Classification ID

Anelastic fracture and damage (74R20) Finite element methods applied to problems in solid mechanics (74S05)

Recommendations

• On the stress distribution around the hole in mechanically fastened joints
• scientific article; zbMATH DE number 1212999
• Modeling by finite element method \`\` blind hole drilling method
• Limit analysis of fastener groups under eccentric load
• Over-critical load analysis for residual stresses and displacement around fastener-holes based on the decohesive failure mechanism and non-linear Mises yield criterion

Cites work

• scientific article; zbMATH DE number 917343 (Why is no real title available?)
• A shrink-fit shaft subject to torsion
• Three-dimensional finite element analysis of cold expansion of adjacent holes

Cited in

(1)

• Finite element- and design of experiment-derived optimization of screw configurations and a locking plate for internal fixation system

Describes a project that uses

Uses Software

• ABAQUS

This page was built for publication: A combined upper-bound and elastic-plastic finite element solution for a fastener hole subjected to internal torsion

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q396116)