The plastic distortion of metals
From MaRDI portal
Publication:4479451
Cited in
(37)- An investigation of yield surfaces based on dislocation mechanics. II: Application
- Unified elastoplastic finite difference and its application
- Continuum plasticity at finite strain for stress paths of arbitrary composition and direction
- A study of the residual stress induced by shot peening for an isotropic material based on prager's yield criterion for combined stresses
- Decreasing of the initial shear modulus with increasing axial strain explained by means of a plastic-hypoelastic model
- Second order effects in the theory of plasticity
- Effective Stress and Effective Strain in Relation to Stress Theories of Plasticity
- A new Drucker yield function for orthorhombic aggregates of cubic crystallites
- The generalized plane strain of an elastoplastic material
- Spectral database constitutive representation within a spectral micromechanical solver for computationally efficient polycrystal plasticity modelling
- Adaptive Lagrangian modelling of ballistic penetration of metallic targets
- Yield functions that account for the effects of initial and subsequent plastic anisotropy
- A theory of linear plasticity for plane strain
- \textit{von Mises} hypothesis revised
- Tri-axial deformation of a plastic-rigid solid
- Transverse deflection of a clamped mild-steel plate
- Effect of intermediate principal stress on flat-ended punch problems
- An elementary derivation of the maximum shear stress in a three dimensional state of stress
- A gradient theory of small-deformation, single-crystal plasticity that accounts for GND-induced interactions between slip systems
- An investigation of yield surfaces based on dislocation mechanics. I: Basic theory
- Second-order plasticity and the slip-line field
- Numerical implementation of a \(J_2\)- and \(J_3\)-dependent plasticity model based on a spectral decomposition of the stress deviator
- Generalized isotropic yield criterion for incompressible materials
- A critical review of the state of finite plasticity
- The associated flow rule of plasticity
- Anisotropic yield criterion for metals exhibiting tension-compression asymmetry
- Constitutive equation of a non-simple elastic plastic material
- Anisotropic yield surfaces after large shear deformations in pearlitic steel
- Model verification of Lode's test results and yield function of isotropic FCC polycrystal
- Analysis of circular hole expansion with generalized yield criteria
- Euler-Lagrange equations governing the flow of solids by extended slip with applications to plane torsion
- A failure criterion for homogeneous and isotropic materials distinguishing the different effects of hydrostatic tension and compression
- New interpretation of cyclic swift effects
- Zur Modifikation des Spannungsdeviators
- Effect of elastic modulus variation during plastic deformation on uniaxial and multiaxial ratchetting simulations
- Stress-Strain Rate Relations for Anisotropic Plastic Flow
- Elastoplasticity beyond small deformations
This page was built for publication: The plastic distortion of metals
Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q4479451)
