Calculation of flow-induced residual stresses in injection moulded products

DOI10.1007/BF02027964MaRDI QIDQ5750552zbMATH OpenOpenAlexFDO

Authors Lucien F. A. Douven, Frank P. T. Baaijens

Publication date 1991

Published in Applied Scientific Research (Search for Journal in Brave)

Full work available at URL https://doi.org/10.1007/bf02027964

zbMATH Keywords

amorphous thermoplastic polymersFlow-induced residual stressesinjection mouldingLeonov model

Mathematics Subject Classification ID

Viscoelastic fluids (76A10)

Recommendations

• Thermoviscoelastic simulation of thermally and pressure-induced stresses in injection moulding for the prediction of shrinkage and warpage for fibre-reinforced thermoplastics
• Computing flow-induced stresses of injection molding based on the Phan-Thien-Tanner model
• Numerical prediction of process-induced residual stresses in glass bulb panel
• Simulation of polymeric flows in the injection moulding process
• Modeling and simulation of residual stresses during glass bulb pressing process

Cited in

(6)

• Computing flow-induced stresses of injection molding based on the Phan-Thien-Tanner model
• Thermoviscoelastic simulation of thermally and pressure-induced stresses in injection moulding for the prediction of shrinkage and warpage for fibre-reinforced thermoplastics
• Infiltration condition and mouldability diagram in resin injection moulding
• Effect of process parameters on injection compression molding of pickup lens
• Simulations of three-dimensional thermal residual stress andwarpage in injection molding
• Numerical prediction of process-induced residual stresses in glass bulb panel

This page was built for publication: Calculation of flow-induced residual stresses in injection moulded products

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q5750552)