Modelling and simulation of moving interfaces in gas-assisted injection moulding process
From MaRDI portal
Publication:614405
DOI10.1016/J.APM.2010.06.002zbMATH Open1202.76145OpenAlexW2060348183MaRDI QIDQ614405FDOQ614405
Authors: Qiang Li, Jie Ouyang, Tao Jiang, Binxin Yang 
Publication date: 27 December 2010
Published in: Applied Mathematical Modelling (Search for Journal in Brave)
Full work available at URL: https://doi.org/10.1016/j.apm.2010.06.002
Recommendations
- Filling simulation and gas penetration modeling for gas-assisted injection molding
- Numerical simulation of gas-assisted injection molding using CLSVOF method
- Numerical simulation of gas-assisted injection molding process for a door handle
- Three-dimensional finite element solution of gas-assisted injection moulding
- Numerical simulation of the fountain flow instability in injection molding
Liquid-gas two-phase flows, bubbly flows (76T10) Viscoelastic fluids (76A10) Dynamics of phase boundaries in solids (74N20)
Cites Work
- A level set approach for computing solutions to incompressible two-phase flow
- Level set methods and dynamic implicit surfaces
- Numerical study of the turbulent flow past an airfoil with trailing edge separation
- Weighted ENO Schemes for Hamilton--Jacobi Equations
- Numerical simulation of nonlinear elastic flows with a general collocated finite volume method
- Plane contraction flows of upper convected Maxwell and Phan-Thien-Tanner fluids as predicted by a finite volume method
- On the gas-penetration in straight tubes completely filled with a viscoelastic fluid
- The development of a free surface capturing approach for multidimensional free surface flows in closed containers
Cited In (10)
- Title not available (Why is that?)
- Numerical simulation of melt filling process in complex mold cavity with insets using IB-CLSVOF method
- Numerical simulation of gas-assisted injection molding using CLSVOF method
- Numerical simulation of gas-assisted injection molding process for a door handle
- New analytical and CWENO numerical solutions for axisymmetric horizontal flows with heat sources
- Filling simulation and gas penetration modeling for gas-assisted injection molding
- A corrected smoothed particle hydrodynamics method for solving transient viscoelastic fluid flows
- Incompressible-compressible flows with a transient discontinuous interface using smoothed particle hydrodynamics (SPH)
- Lattice Boltzmann Modeling of Injection Moulding Process
- Continuous modeling and simulation of flow-swell-crystallization behaviors of viscoelastic polymer melts in the hollow profile extrusion process
This page was built for publication: Modelling and simulation of moving interfaces in gas-assisted injection moulding process
Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q614405)
