Finite element modeling of residual stresses in machining induced by cutting using a tool with finite edge radius

DOI10.1016/J.IJMECSCI.2005.06.001MaRDI QIDQ986272zbMATH OpenOpenAlexFDO

Authors K. C. Ee, O. W. jun. Dillon, I. S. Jawahir

Publication date 11 August 2010

Published in International Journal of Mechanical Sciences (Search for Journal in Brave)

Full work available at URL https://doi.org/10.1016/j.ijmecsci.2005.06.001

zbMATH Keywords

finite element methodmachiningresidual stresses

Mathematics Subject Classification ID

Small-strain, rate-dependent theories of plasticity (including theories of viscoplasticity) (74C10) Thermal effects in solid mechanics (74F05) Contact in solid mechanics (74M15) Finite element methods applied to problems in solid mechanics (74S05)

Recommendations

• Finite element analysis of the effect of sequential cuts and tool-chip friction on residual stresses in a machined layer
• A new stress-based model of friction behavior in machining and its significant impact on residual stresses computed by finite element method
• Thermal and mechanical numerical modelling of electric discharge machining process
• scientific article; zbMATH DE number 1617994
• Modelling and simulation of machining processes

Cited in

(6)

• Finite element analysis of the effect of sequential cuts and tool-chip friction on residual stresses in a machined layer
• A new stress-based model of friction behavior in machining and its significant impact on residual stresses computed by finite element method
• A study of deformation of the machined workpiece and tool under different low cutting velocities with an elastic cutting tool
• Modelling and simulation of machining processes
• Thermal and mechanical numerical modelling of electric discharge machining process
• Slip-line modeling of built-up edge formation in machining

This page was built for publication: Finite element modeling of residual stresses in machining induced by cutting using a tool with finite edge radius

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q986272)