Numerical modeling of the fluid flow in continuous casting tundish with different control devices (Q2319340): Difference between revisions
From MaRDI portal
Added link to MaRDI item. |
Set OpenAlex properties. |
||
| (2 intermediate revisions by 2 users not shown) | |||
| Property / describes a project that uses | |||
| Property / describes a project that uses: OpenFOAM / rank | |||
Normal rank | |||
| Property / MaRDI profile type | |||
| Property / MaRDI profile type: MaRDI publication profile / rank | |||
Normal rank | |||
| Property / full work available at URL | |||
| Property / full work available at URL: https://doi.org/10.1155/2013/984894 / rank | |||
Normal rank | |||
| Property / OpenAlex ID | |||
| Property / OpenAlex ID: W1979472173 / rank | |||
Normal rank | |||
Revision as of 03:41, 20 March 2024
scientific article
| Language | Label | Description | Also known as |
|---|---|---|---|
| English | Numerical modeling of the fluid flow in continuous casting tundish with different control devices |
scientific article |
Statements
Numerical modeling of the fluid flow in continuous casting tundish with different control devices (English)
0 references
16 August 2019
0 references
Summary: Numerical simulations were conducted to study the melt flow under the influence of control devices in a T-type two-strand bloom caster tundish via the open source Computational Fluid Dynamics software OpenFOAM. Three different cases were studied: a bare tundish, a tundish with two pairs of baffles, and a tundish equipped with a turbulence inhibitor and a pair of baffles. Turbulence inhibitor and baffles arrangement showed an improvement of the fluid flow characteristics, yielding lower values of dead volume and higher values of plug flow. With a turbulence inhibitor, the velocity of metal which flows directly toward the tundish floor is smaller and the turbulence kinetic energy of the melt top surface is lower than the other two arrangements.
0 references
