Discontinuous solutions to hyperbolic systems under operator splitting

From MaRDI portal





This article is concerned with two-dimensional systems of time-dependent partial differential equations. We write these in their matrix form (1) \({\mathbf u}_ t+A{\mathbf u}_ x+B{\mathbf u}_ y=0\). Attention is restricted to the hyperbolic case, characterized by the fact that the \(n\times n\) matrix \((A\cos \varphi+B\sin\varphi)\) possesses a full set of independent eigenvectors for all angles \(\varphi\). Physically, this corresponds to the fact that for any direction \(\varphi\) it is possible to construct \(n\) different families of plane-wave solutions traveling in that direction. A common technique for solving (1) numerically is that of operator splitting. The operation of advancing (1) through a time interval \(\Delta t\) is replaced, in the simplest case, by the following two operations. First, the data is advanced by \(1/2\cdot\Delta t\) by means of the one-dimensional operator \({\mathbf u}_ t+2\cdot A{\mathbf u}_ x=0\) and then the new solution is advanced through \(1/2\cdot\Delta\) by means of \({\mathbf u}_ t+2\cdot B{\mathbf u}_ x=0\). Repetition of this pair of operators \(N\) times is assumed to be equivalent to advancing (1) by \(N\cdot\Delta t\). The attraction of the strategy is that is allows use to be made of very accurate and sophisticated one-dimensional numerical schemes. Most users of operator splitting codes for computational fluid dynamics feel some unease concerning the correctness of the procedure. This is particularly the case when the one-dimensional methods employed are based on characteristic analysis and aim to achieve highly resolved shock waves. It is well known that operator splitting will create errors in the treatment of flow discontinuities. Singularities of the solution may be shocks, expansions, or contacts, corresponding to converging, diverging or parallel characteristics. The error discussed in this article arises even at the linear level if there is more than one unknown. The initial data is a step functions across an oblique discontinuity. The manner in which this discontinuity breaks up under repeated applications of the split operator is analyzed, and it is shown that the split solution will fail to match the true solution in any case where the two operators do not share all their eigenvectors. The special case of the fluid flow equations is analyzed in more detail, and it is shown that arbitrary initial data gives rise to `` pseudo acoustic waves and a nonphysical stationary wave. The implications of these findings for the design of high-resolution computing schemes are discussed. Therefore, the results do not relate to any particular numerical scheme, but can be used to explain certain anomalies that are observed in practice, and to suggest the kind of scheme that can be employed in given problems.




Cited in
(20)








This page was built for publication: Discontinuous solutions to hyperbolic systems under operator splitting

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q3978215)