Interactive buckling analysis with finite strips

From MaRDI portal





This paper is concerned with the study of interaction of two types of modes which appear mainly in the buckling of thin-walled structures: local and overall modes. The local mode is characterized by individual plate elements buckling out of plane with the junctions remaining essentially straight. Overall buckling may be either purely flexural (Euler type) or lateral torsional. This paper constitutes a generalization and a logical sequel to the earlier publications of the authors [e.g.: the second author, Int. J. Solids Struct. 19, 625-641 (1983; Zbl 0517.73039) and together with \textit{T. R. Graves Smith}, Int. J. Mech. Sci. 20, 685-693 (1978; Zbl 0388.73043)]. Their works are based on an analytical technique which combines the powerful tools of finite strip analysis and the theory of mode interaction. According to the theory of mode interaction, the generic displacement, strain and stress are written in the form of a development whose variables are the load parameter \(\lambda\) and the two unknowns \(\xi_ 1\) and \(\xi_ 2\), i.e., the scaling factors of the participating modes of buckling. Next, the strain-displacement relations are given in the context of nonlinear thin plate theory using Kirchhoff's hypothesis. Whereas the constitutive relations assume that the material is linearly elastic and isotropic. After some appropriate simplifications, the authors obtain the total potential energy \(\Phi\) for the mode interaction problem and the equilibrium equations are produced by setting \(\partial \Phi /\partial \xi_ 1=0,\quad \partial \Phi /\partial \xi_ 2=0\); initial imperfections can be easily taken into account. Then, some indications concerning the numerical scheme and computer implementation are given. Numerical examples are presented to illustrate the scope and the convergence characteristics of the solution. One of these examples is a doubly symmetric system (an I-column, simply supported at the ends, subjected to uniform compressive stress), and the other is a singly symmetric system (channel, simply supported at the ends, subjected to uniform compressive stress). Finally, in order to illustrate the scope of their analysis, the authors consider the interaction of local and lateral-torsional buckling in a beam subjected to end moments. In this way, they use a set of three T-section beams having near coincident critical stresses. It is seen that the imperfection-sensitivity is given rise to, not by the torsional component but by the flexural component of the overal buckling deformation.











This page was built for publication: Interactive buckling analysis with finite strips

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q3691180)