Modelling drawbeads in sheet metal forming

DOI10.1016/0020-7403(95)00033-TMaRDI QIDQ1905619zbMATH OpenOpenAlexFDO

Authors Patrick Chabrand, Frédéric Dubois, Jean-Claude Gelin

Publication date 8 February 1996

Published in International Journal of Mechanical Sciences (Search for Journal in Brave)

Full work available at URL https://doi.org/10.1016/0020-7403(95)00033-t

zbMATH Keywords

experimental datafriction

Mathematics Subject Classification ID

Theories of friction (tribology) (74A55) Large-strain, rate-independent theories of plasticity (including nonlinear plasticity) (74C15) Large-strain, rate-dependent theories of plasticity (74C20) Contact in solid mechanics (74M15) Finite element methods applied to problems in solid mechanics (74S05)

Review text

A numerical modelling of drawbead forces required to draw a sheet metal through a bead is described. An elastoplastic constitutive relation combined with the finite element method is used to investigate the contact and friction conditions. The results obtained are compared with experimental data proving a good agreement.

Recommendations

• Expert drawbead models for finite element analysis of sheet metal forming processes
• A numerical method for rapid estimation of drawbead restraining force based on nonlinear, anisotropic constitutive equations
• Optimization of drawbead restraining forces and drawbead design in sheet metal forming process
• scientific article; zbMATH DE number 2161512
• A new cyclic anisotropic model for plane strain sheet metal forming

Cited in

(10)

• Optimization of drawbead restraining forces and drawbead design in sheet metal forming process
• Analysis of draw-redraw processes
• Identification of geometric parameters of drawbead in metal forming processes
• A modified Tikhonov regularization method for parameter estimations of a drawbead model
• scientific article; zbMATH DE number 2037762 (Why is no real title available?)
• scientific article; zbMATH DE number 2161512 (Why is no real title available?)
• Expert drawbead models for finite element analysis of sheet metal forming processes
• Various numerical methods for solving unilateral contact problems with friction
• Drawing and extrusion of composite sheets, wires and tubes
• A numerical method for rapid estimation of drawbead restraining force based on nonlinear, anisotropic constitutive equations

This page was built for publication: Modelling drawbeads in sheet metal forming

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q1905619)