Parameterisation of developable surfaces by asymptotic lines

From MaRDI portal





According to A. V. Pogorelov, a \(C^1\) smooth surface \(F^3\) in 3-dimensional Euclidean space of bounded (resp. vanishing) exterior curvature is a surface with bounded (resp. vanishing) total variation of the spherical Gauss map. In the vanishing case, \(F^2\) consists of flat and ruled parts; every generator (rectilinear segment) of a ruled part has a tangent plane stable along it and both ends of the generator line on the boundary of \(F^2\) (or at \(\infty)\); a flat part is a piece of a plane and can go out to the boundary of \(F^2\) or be bounded by rectilinear segments, each of which joins two points of the boundary of \(F^2\) (or goes to \(\infty)\). A complete surface of vanishing exterior curvature is a cylinder. Every ruled surface has a standard parametrization (by asymptotic lines) \[ r(u,v)= \rho(u)+ \nu\cdot s(u), \] where the non-vanishing vector-valued function \(s(u)\) gives the directions of the generators. Let \(F^2\) be a \(C^2\)-surface over the unit disk \(D\) which has vanishing Gauss curvature and let the set of non-planar points be dense on \(D\). \textit{Ph. Hartman} and \textit{L. Nirenberg} [Am. J. Math. 81, 901-920 (1959; Zbl 0094.16303)] proved that there exists a standard reparametrization such that \(\rho(u)\) is \(C^2\) and \(s(u)\) is \(C^0\). If there are no planar points, then \(s(u)\) is \(C^1\), but for a general surface \(s(u)\) is not \(C^2\). If there exists a least one planar point (hence, a line segment of planar points), then in general \(s(u)\) is not \(C^1\). In this paper an example is given which describes precisely the second case; it was presented by W. Klingenberg in 1978, but in a rather vague form. Now the example is described in detail. The surface consists of two cones glued together along their common generator, but the movement of a straight line is only continuous and is not \(C^1\). The jump in the derivative of the direction vector of the generators belongs to the tangent space of the surface and does not influence the exterior geometry of the surface, which is \(C^\infty\)-smooth. Also, other examples of smooth developable surfaces not allowing smooth standard parametrization are analysed.











This page was built for publication: Parameterisation of developable surfaces by asymptotic lines

Report a bug (only for logged in users!)Click here to report a bug for this page (MaRDI item Q4346921)